The use of building film face plywood small details
In the current plate industry, building film face plywood is more and more popular, the use of the scope of use is becoming more and more widely, building film face plywood manufacturers feel at the time of using building film face plywood, inside should be clean, it is helpful for future use.To get more news about
, you can visit boosterplywood.com official website.
So when using building film face plywood, will encounter a lot of its situation, the first is at the time of use, if development of slurry leakage phenomenon, this will cause the appearance of honeycomb pitting surface of concrete, directly affect the quality of concrete, so no matter what material construction template, the seam should be tight, do not leak slurry. Because wood is made of water absorption, water absorption is found in the process of increases, but at the time of installation, joint shoulds not be too tight, should be water wet after the installation is complete, make board joint closure. In building templates, embedded parts on the fixed building templates, reserve a hole and the hole, not legacy, size meet the requirements, the effect of the installation will be more good. As well as in besmear to brush, try to choose some won't have some effect, such as the layout and get in the way of decoration engineering construction cut off oily agent, and is not permitted in the coating pollution of reinforcement.
So the use of building film face plywood is there are many places need to be aware of, of course, as long as the use of methods is in accordance with the regulations that can avoid some unnecessary influence.
Itself is the biggest characteristic of building film face plywood used materials, color does not fade for a long time, always keep the original color, fear not fade or color becomes weak. Corrosion resistance is stronger, more help to the outer wall decoration. The original template is easy to corrosion, and after dealing with the technology of template is more resistant to corrosion. Whether it's physical properties or chemical properties are more help to the strengthening of the overall corrosion resistance. But also has disadvantages, when use will be at the time of use because of degumming phenomenon, the reason is that there are many, mainly in the single board selects the agglutination, the selection of solvent, hot pressing time control, one of the hot pressing time control need production personnel to make use of the principle of hot press and combining its own characteristics of the product. And in the processing technology of veneer, veneer of water content.
But we must pay attention to when the choice, the materials used, usually choose low cost, efficiency is good, quality first-class raw materials. But because the production of different kinds, so when select material, also can choose different materials according to the situation. When building film face plywood in production, will use high quality raw materials, thus produced products are high quality products.
